Pvc Kayak Transducer Arm
This is a diy kayak track mounted transducer arm made using the following parts: ram 1" ball slip pipe socket (ram4967) ram 1" ball single socket arm w/octagon socket (ram1918) ram 1" diamond base. Diy kayak transducer arm for the 2012 wilderness systems ride 135 i have received a lot of questions on how i fabricated the rear transducer arm for my 2012 ride 135. there are a few elements i may update with this setup in the future, but i really like the way it works as-is.. The railblaza transducer arm has been developed for kayak anglers needing an easy way to install and remove fish finder traducers. with this kit you can install and uninstall your transducer in a matter of seconds, no messy adhesives or excessive drilling of fittings required..
So i finally got to install my ff unit but the big question was the way i wanted the transducer to be installed with nk previous exprerience it was even harder to get it done but i ended up going with the arm since i wanted to be semi removable so i can still be capable to launch on the beach and no to be worry about draging it on the sand.. Diy kayak transducer arm for the 2012 wilderness systems ride 135 i have received a lot of questions on how i fabricated the rear transducer arm for my 2012 ride 135. there are a few elements i may update with this setup in the future, but i really like the way it works as-is.. Fishfinder transducer arm set up; dremel’ed pvc fitting for transducer; harmony slidetrax tie down there is a high torque on the joint at the scotty port, bending force on the pvc arm, and some pulling force as well. so we do anticipate that this arm design will have quite a bit of flex at moderate speed, and plan to limit its usage to.
